Ofm 420 Manuel d'utilisateur télécharger pdf

5mm Allen Wrench

1 Unit

Back Cushion

1 Unit

Seat Cushion

1 Unit

Frame / Legs

2 Units

Screws

8 Units

Assembly Notes:

During assembly, hand tighten screws only. When all screws

are in place, you may then tighten all screws completely.

CAUTION:

1. Do not use this chair as a step ladder.

2. Check for loose screws and tighten them every 6 months.

Model: 420 UNO Lounge Chair

WEIGHT CAPACITY: 250 lbs.

Parts Listing

12.23.2013

STOP

Assembly Instructions

Tools Needed: Allen Wrench and a Standard Screw Driver.

Step 1: Insert the Frame/Legs (C) into the large holes in

the Back Cushion (A) and the large holes in the

Seat Cushion (B) as shown.

Step 2: Align the holes in the Frame/Legs (C) with the

corresponding holes in the Back Cushion (A)

and Seat Cushion (B).

Step3: Insert Screws (D) through the holes in the

Frame/Legs (C). Tighten by hand.

Step 4: When all screws are in place, tighten with Allen

Wrench.

Step 5: If applicable, attach Ganging Bracket (E) to

Frame/Legs (C) using Ganging Bracket Screw (F)

and Ganging Bracket Nut (G). Tighten using

Screw Driver.

Ganging Bracket Screw

2 Units

Ganging Brackets

2 Sets

Ganging Bracket Nut

2 Units

Tweet with us on twitter at twitter.com/ofminc

Watch us on youtube at youtube.com/ofminc

161 Tradition Trail, Holly Springs, NC, 27540

800-520-7471 (voice) 919-362-4765 (fax)

919-303-6389 (voice) www.ofminc.com

[email protected]

Model: 420 UNO Lounge Chair 1

Résumé du contenu

Page 1 - Model: 420 UNO Lounge Chair

5mm Allen Wrench1 UnitABack Cushion1 UnitBSeat Cushion1 UnitCFrame / Legs2 UnitsDScrews8 UnitsAssembly Notes: During assembly, hand tighten screws onl

Commentaires sur ces manuels

Pas de commentaire

Ofm 420 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Meubles Ofm 420. OFM 420 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Meubles Ofm 420